Skip to content

WM320 Gimbal driver pitch

Jump to bottom
mefistotelis edited this page Apr 2, 2017 · 35 revisions

Function

The Gimbal Driver Pitch board contains ICs to drive the Pitch Motor.

Variants

Boards for P3X start from V3. Each pitch board variant has a corresponding roll board variant.

Marking Overview
Driver Pitch V3 Phantom 3 Pro/Adv early
Driver Pitch V4 Phantom 3 Pro/Adv update 1
P009??.05 (V5) Phantom 3 Pro/Adv update 2

Parts

Version P009??.05 components

Marking Amt. Function Specification
HV232Q 4CM 1 3.3V CAN transciever
ADEF 329 1

Programming

TODO

External interfaces

There are two connectors on the board:

Marking Overview
14-pin FFC con. Flex flat cable connector
10-pin FFC con. Flex flat cable connector

Service interfaces

The service pads marking and placement is identical to the Gimbal driver roll board.

Board view

Top of the v4 board:

WM320 Gimbal driver pitch v4 top

Bottom of the v4 board:

WM320 Gimbal driver pitch v4 bottom

Bottom of the v5 board:

WM320 Gimbal driver pitch v4 bottom

Bottom of the board in unknown version, but with chip markings visible:

WM320 Gimbal driver pitch board vXa bottom

Schematics

No schematics available.

This page is created by drone enthusiasts for drone enthusiasts.

If you see a mistake, or you know more about specific subject, or you see an area for improvement for the wiki - create an issue in this project and attach your patch (or describe the change you propose).

Clone this wiki locally