WM320 Gimbal driver pitch
Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics
The Gimbal Driver Pitch board contains ICs to drive the Pitch Motor.
Boards for P3X start from V3. Each pitch board variant has a corresponding roll board variant.
| Marking | Overview |
|---|---|
| Driver Pitch V3 | Phantom 3 Pro/Adv early |
| Driver Pitch V4 | Phantom 3 Pro/Adv update 1 |
| P00954.05 | Phantom 3 Pro/Adv update 2 |
| Marking | Amt. | Function | Specification |
|---|---|---|---|
| HV232Q 4CM | 1 | 3.3V CAN transciever | |
| ADEF 329 | 3 | MOSFET N-Channel |
TODO
There are two connectors on the board:
| Marking | Overview |
|---|---|
| 14-pin FFC con. | Flex flat cable connector |
| 10-pin FFC con. | Flex flat cable connector |
The service pads marking and placement is identical to the Gimbal driver roll board.
Top of the v4 board:
Bottom of the v4 board:
Bottom of the v5 board:
Bottom of the board in unknown version, but with chip markings visible:
View on the P00954.05 clean PCB (without components):
No schematics available.