-
Notifications
You must be signed in to change notification settings - Fork 130
Items Irrigation_Item
ggodart edited this page Jan 2, 2021
·
1 revision
See original
Defined in items.mht as
# First, define your actual irrigation object:
UPB_Rain8, irrigation_controller1, 13, 1
# Then, define the Irrigation_Item(s) and attach the real object:
IRRIGATION, irrigation_controller1, morning_irrigation
IRRIGATION, irrigation_controller1, evening_irrigation
Irrigation Cycle controller - This is an attempt to abstract irrigation control features from the hardware specific device driver. This driver can cycle through specific zones with specified time delays (much like a generic sprinkler controller found on an existing system) This driver has been tested to work with the UPB_Rain8 driver, but should work with any other device object that can turn on/off its zones using the MH support substate syntax ( ->set(on:4);)
None
| Method | Description |
|---|---|
set(state) |
Start / Stop full irrigation cycle state[on/off] = Start/Stop full irrigation cycle |
zone_single(zone,state,time) |
Start / Stop single zone zone[x] = Single zone to activate/deactivate state[on/off] = Start / Stop single zone time[x] = Time in seconds for the zone to run |
zone_activate(zone,activated) |
Set zone activation part of the cycle zone[x] = Zone to set activate/de-activated activated[1/0] = Set / unset active zone in full cycle |
zone_time(zone,time) |
Set zone cycle time zone[x] = Zone to set cycle time time[x] = Time in seconds for the zone to run part of the cycle |
zone_count(zones) |
Set total zones zones[x] = Number of zones as a part of the system (default 8) |
zone_hammer(time) |
Set anti-water hammer time (seconds) time[x] = Time in seconds for overlapping zones |
running() |
Returns (1/0) system running |
zone_current() |
Returns [1/0] current zone running |
Jason Sharpee - jason@sharpee.com
None