RFTools Matter Beamer

Matter Beamer

The Matter Beamer sends out enerergized matter in the form of a laser. You connect it to a spawner by selecting first the beamer and then the spawner with a wrench.

Every type of mob has different material requirements but you will always need three types. For that reason it is recommended that you use at minimum three lasers. You can potentially use a single laser if you alternate between the different types of materials but that will be rather slow.

If you increase the number of lasers you can increase the spawning rate. Pay attention to the amount of materials needed (you can see that after inserting a correct syringe in the spawner) and distribute your beamers accordingly. i.e. if the spawner needs twice as much dirt as it needs living matter then you should preferably use twice as many dirt lasers.

Tip: using the sequencer you can make sure you don't waste too much key material (typically the loot of the mob) because you usually only need 0.1 of that for every single mob. The 'loop4' mode of the sequencer is useful for that.

Infusing the beamer can drastically increase the speed (up to three times) as well as reduce power usage.