-
Notifications
You must be signed in to change notification settings - Fork 20
Recent Changes Notice
In 2021.12.x the motor torque messages that CANserver uses for displays were changed by Tesla. This will affect bargraphs and displays showing torque. Simple go to the Analysis page, find the 0x1D8 Rear Torque message, and set startbit to 21, length to 13, scale to 0.222, and offset to 0. Click the disk icon on the right to save the changes.
In 2020.40.x, Tesla moved the 0x00C UI message that was used to turn off the microDisplays with the center display.
You simply have to update the DisplayOn signal under the Analysis tab to the new message ID.
Log into your CANserver with a web browser, click the Analysis tab, and find the DisplayOn signal.
Change the next field from 0x00C to 0x353 then click the disk icon to the right to save the change.
Displays should work properly again.