API: Not sure how to set samplers after recent update....? #2323
-
|
Until yesterday I've used the API to send tasks to SD.NEXT using, for example, the following command: However, I haven't been able to process anything since the recent update. The main reason appears to be that the sampler parameter will not work anymore:
Within the UI you are now required to a) set "DPM++ 2M" and b) set "Karras" separately if I understand it correctly. How would I achieve the same using the API? I don't see any related "sigma algorithm" parameter? Thank you for your help |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
|
Karras, sigma, etc - those are all settings, not params, so you set them as you would settings. And then call txt2img api with sampler name as usual at it will use whatever setting you applied. |
Beta Was this translation helpful? Give feedback.
-
|
First of all: your response time is insane! Thank you very much. Second: understood. I will experiment in that regard. If I recall correctly there might even be an API method to change "settings" so this might only be a matter of sending two requests then. |
Beta Was this translation helpful? Give feedback.
-
|
yes, settings are set using single api call and its near-instant, can be 1 or 100 settings as payload for that call. |
Beta Was this translation helpful? Give feedback.
Karras, sigma, etc - those are all settings, not params, so you set them as you would settings. And then call txt2img api with sampler name as usual at it will use whatever setting you applied.