mtd: rawnand: Correct multiple typos in comments

Fixed some confusing spelling errors, the details are as follows:

-in the code comments:
	remaing		-> remaining
	alingment	-> alignment
	capabilitiies	-> capabilities
	operatoin	-> operation
	decriptors	-> descriptors
	stareted	-> started
	Unfortunelly	-> Unfortunately
	compatabable	-> compatible
	depenent	-> dependent

Signed-off-by: Shen Lichuan <shenlichuan@vivo.com>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/20240923065649.11966-1-shenlichuan@vivo.com

drivers/mtd/nand/raw/brcmnand/brcmnand.c

@@ -1561,7 +1561,7 @@ static int write_oob_to_regs(struct brcmnand_controller *ctrl, int i,
 				(oob[j + 2] <<  8) |
 				(oob[j + 3] <<  0));
 
-	/* handle the remaing bytes */
+	/* handle the remaining bytes */
 	while (j < tbytes)
 		plast[k++] = oob[j++];
 

drivers/mtd/nand/raw/cadence-nand-controller.c

@@ -1891,7 +1891,7 @@ static int cadence_nand_read_buf(struct cdns_nand_ctrl *cdns_ctrl,
 
 		int len_in_words = (data_dma_width == 4) ? len >> 2 : len >> 3;
 
-		/* read alingment data */
+		/* read alignment data */
 		if (data_dma_width == 4)
 			ioread32_rep(cdns_ctrl->io.virt, buf, len_in_words);
 #ifdef CONFIG_64BIT

drivers/mtd/nand/raw/cs553x_nand.c

@@ -26,7 +26,7 @@
 
 #define NR_CS553X_CONTROLLERS	4
 
-#define MSR_DIVIL_GLD_CAP	0x51400000	/* DIVIL capabilitiies */
+#define MSR_DIVIL_GLD_CAP	0x51400000	/* DIVIL capabilities */
 #define CAP_CS5535		0x2df000ULL
 #define CAP_CS5536		0x5df500ULL
 

drivers/mtd/nand/raw/nand_macronix.c

@@ -113,7 +113,7 @@ static void macronix_nand_onfi_init(struct nand_chip *chip)
 	rand_otp = of_property_read_bool(dn, "mxic,enable-randomizer-otp");
 
 	mxic = (struct nand_onfi_vendor_macronix *)p->onfi->vendor;
-	/* Subpage write is prohibited in randomizer operatoin */
+	/* Subpage write is prohibited in randomizer operation */
 	if (rand_otp && chip->options & NAND_NO_SUBPAGE_WRITE &&
 	    mxic->reliability_func & MACRONIX_RANDOMIZER_BIT) {
 		if (p->supports_set_get_features) {

drivers/mtd/nand/raw/pl35x-nand-controller.c

@@ -187,7 +187,7 @@ static const struct mtd_ooblayout_ops pl35x_ecc_ooblayout16_ops = {
 	.free = pl35x_ecc_ooblayout16_free,
 };
 
-/* Generic flash bbt decriptors */
+/* Generic flash bbt descriptors */
 static u8 bbt_pattern[] = { 'B', 'b', 't', '0' };
 static u8 mirror_pattern[] = { '1', 't', 'b', 'B' };
 

drivers/mtd/nand/raw/r852.c

@@ -335,7 +335,7 @@ static void r852_cmdctl(struct nand_chip *chip, int dat, unsigned int ctrl)
 		else
 			dev->ctlreg &= ~R852_CTL_WRITE;
 
-		/* when write is stareted, enable write access */
+		/* when write is started, enable write access */
 		if (dat == NAND_CMD_ERASE1)
 			dev->ctlreg |= R852_CTL_WRITE;
 
@@ -372,7 +372,7 @@ static int r852_wait(struct nand_chip *chip)
 
 	nand_status_op(chip, &status);
 
-	/* Unfortunelly, no way to send detailed error status... */
+	/* Unfortunately, no way to send detailed error status... */
 	if (dev->dma_error) {
 		status |= NAND_STATUS_FAIL;
 		dev->dma_error = 0;

drivers/mtd/nand/raw/sm_common.c

@@ -52,8 +52,8 @@ static const struct mtd_ooblayout_ops oob_sm_ops = {
 	.free = oob_sm_ooblayout_free,
 };
 
-/* NOTE: This layout is not compatabable with SmartMedia, */
-/* because the 256 byte devices have page depenent oob layout */
+/* NOTE: This layout is not compatible with SmartMedia, */
+/* because the 256 byte devices have page dependent oob layout */
 /* However it does preserve the bad block markers */
 /* If you use smftl, it will bypass this and work correctly */
 /* If you not, then you break SmartMedia compliance anyway */