[dropconfig] Clean-up error output for devices that do not support drop counters #784
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Signed-off-by: Danny Allen daall@microsoft.com
- What I did
I fixed the if-check for devices that do not publish any drop counter capabilities to state DB.
- How I did it
I added a return inside the if-check so that the function will stop if no capabilities are found.
- How to verify it
I ran the
show dropcounters capabilities
command immediately after boot to ensure that the CAPABILITIES table would be empty, triggering the if-check.- Previous command output (if the output of a command-line utility has changed)
- New command output (if the output of a command-line utility has changed)