🔥 Clean up SCARA/TPARA

Marlin/Configuration.h

@@ -1006,9 +1006,6 @@
     // Radius around the center where the arm cannot reach
     #define MIDDLE_DEAD_ZONE_R   0  // (mm)
 
-    #define THETA_HOMING_OFFSET  0  // Calculated from Calibration Guide and M360 / M114. See https://www.morgan3dp.com/morgan-calibration-guide/
-    #define PSI_HOMING_OFFSET    0  // Calculated from Calibration Guide and M364 / M114. See https://www.morgan3dp.com/morgan-calibration-guide/
-
   #elif ENABLED(MP_SCARA)
 
     #define SCARA_OFFSET_THETA1  12 // degrees
@@ -1027,23 +1024,19 @@
   #define DEFAULT_SEGMENTS_PER_SECOND 200
 
   // Length of inner and outer support arms. Measure arm lengths precisely.
-  #define TPARA_LINKAGE_1 120       // (mm)
-  #define TPARA_LINKAGE_2 120       // (mm)
+  #define TPARA_LINKAGE_1 120     // (mm)
+  #define TPARA_LINKAGE_2 120     // (mm)
 
-  // SCARA tower offset (position of Tower relative to bed zero position)
-  // This needs to be reasonably accurate as it defines the printbed position in the SCARA space.
-  #define TPARA_OFFSET_X    0       // (mm)
-  #define TPARA_OFFSET_Y    0       // (mm)
-  #define TPARA_OFFSET_Z    0       // (mm)
+  // TPARA tower offset (position of Tower relative to bed zero position)
+  // This needs to be reasonably accurate as it defines the printbed position in the TPARA space.
+  #define TPARA_OFFSET_X    0     // (mm)
+  #define TPARA_OFFSET_Y    0     // (mm)
+  #define TPARA_OFFSET_Z    0     // (mm)
 
   #define FEEDRATE_SCALING        // Convert XY feedrate from mm/s to degrees/s on the fly
 
   // Radius around the center where the arm cannot reach
   #define MIDDLE_DEAD_ZONE_R   0  // (mm)
-
-  // Calculated from Calibration Guide and M360 / M114. See https://www.morgan3dp.com/morgan-calibration-guide/
-  #define THETA_HOMING_OFFSET  0
-  #define PSI_HOMING_OFFSET    0
 #endif
 
 // @section polar