WLAN Pi
Charging Status on POE #14
-
|
just got home and am testing the WLANPi Pro. Charging via POE and the status page shows discharging, while the PoE light is on and the percentage is going up.
|
Beta Was this translation helpful? Give feedback.
Replies: 3 comments
-
|
That would indicate that the WLAN Pi Pro is consuming more energy than is being supplied. Could you check how much power your PSE is delivering? It should be 12W (2A). Is anything connected to the WLAN Pi Pro USB ports that would drawing power? |
Beta Was this translation helpful? Give feedback.
-
|
The pi pro is powering an original wlan pi via USB. However, the battery percentage went from 80% to 100% all while saying “discharging.”
I show it consuming 9.2W currently and it’s topped to 100%.
…Sent from my iPhone
On Feb 27, 2022, at 9:44 PM, jolla ***@***.***> wrote:
That would indicate that the WLAN Pi Pro is consuming more energy than is being supplied. Could you check how much power your PSE is delivering? It should be 12W (2A).
Is anything connected to the WLAN Pi Pro USB ports that would drawing power?
—
Reply to this email directly, view it on GitHub, or unsubscribe.
Triage notifications on the go with GitHub Mobile for iOS or Android.
You are receiving this because you authored the thread.
|
Beta Was this translation helpful? Give feedback.
-
|
Ok, it looks like there is an issue where if more power is being drawn then expected the charging controller misreports as discharging even though it does appear to still be charging. We'll need to investigate this further to see if it can be addressed in a firmware update with the micro controller. |
Beta Was this translation helpful? Give feedback.
Ok, it looks like there is an issue where if more power is being drawn then expected the charging controller misreports as discharging even though it does appear to still be charging. We'll need to investigate this further to see if it can be addressed in a firmware update with the micro controller.