Skip to content
This repository has been archived by the owner on Apr 18, 2022. It is now read-only.

Filament Settings Menu

Jump to bottom
Miguel Risco-Castillo edited this page Dec 30, 2021 · 3 revisions

The filament settings menu allows to setup advanced features for filament management, if you have a BTT Smart filament sensor set the Runout Active to MOTION.

You can use the run-stop diagnostic page for debugging the sensor. When the filament is inside of the sensor you will get a TRIGGERED status, without filament the status is open, if the behavior is inverted change the Runout Active from LOW to HIGH. Remember that the printer will continue to print until a Runout distance is reached.

Get the latest firmware here: https://github.com/mriscoc/Marlin_Ender3v2/releases/latest

Clone this wiki locally