Squat b0xx.
I've printed and tested V1, there are some fixes in the V2 case files that are untested but should work just fine.
I made a few small changes to the way that the two halves connect.
- Increased the size of the inset to make a tighter fit.
- Moved the magnets closer together.
- 1 x Top.stl
- 1 x Plate.stl
- 1 x TopLogo.stl
- 1 x Bottom.stl
- 20 x 20mm MX button from the Fake1
- PCB, I suggest JLCPCB.
- 20 MX keyboard switches.
- 20 Kailh hot swap sockets.
- Raspberry Pico micro controller.
- M2 Standoffs Amazon link
- 4 10mm x 3mm magnets Amazon link
All of the components are soldered on to the back of the PCB. The Pico is soldered flat against the board without a socket. I have added break outs for a hardwired GCC cable if required.
Big shout out to Arte for writing some awesome software, pico-rectangle