Eagle component library files that I've modified or created.
JST-XH headers. Edited 4.10.15 dmf 2 pin, 3 pin, 4 pin all should be OK
Original version (wrong hole sizes) from this fellow: "This libary is for adding JST-XH headers to you're project. It has pins 3-7. This is usefull for ballance connectors on lithium polymer >batteries from 2-6 cells. The pin spacing was based on the datasheet that can be found here http://www.jst->mfg.com/product/pdf/eng/eXH.pdf" Source: http://www.rcgroups.com/forums/showthread.php?t=2304597
Corrected for XH 2/3/4 pin dmf 4.10.15 Source info: http://www.jst-mfg.com/product/pdf/eng/eXH.pdf Note: pin spacing is 2.5 mm Note: pins are 0.64 mm square cross section. This means the pin diagonal is 0.905 mm. Hole diameter spec'd by jst is 0.9 mm; hole diameter used here is 1.0 mm
Weidmuller 1715010000 LM 3.50/135/2
Screw - Clamping Yoke, Tension Sleeve 14-22 AWG
Weidmuller 1715010000 LM 3.50/135/2
Screw - Clamping Yoke, Tension Sleeve 14-22 AWG 3.5 mm pin spacing. Pins have a rectangular profile, 1.1 x 0.75mm. The drill hole diameter for the original version was too large. Corrected drill size to 1.30mm on 4.22.15.
This version modified to eliminate programming headers that are not directly connected to the underlying PCB. The ExtraCore Package is modified to eliminate programming headers (which are at 90° to PCB outline).