Bambu lab X1C. When sending a print job, progress gets stuck at 10% on some models

[FillPavS]

OrcaSlicer Version

1.9.0-dev (Fixed a regression that non spiral vase mode was broken. #3091)

OS version

Windows 10

Additional system information

No response

Printer

Bambu lab X1C

How to reproduce

Open the slicer, load the attached model or project, slice, send for printing

Actual results

Progress gets stuck at 10%. You can wait forever, but nothing happens. If you do the same in the earlier version (dated 09 Dec 23 (Port Emboss & SVG gizmo from PrusaSlicer (#2819)) (Fixed a bug that caused curled edge detection not to work as expected… (https://github.com/SoftFever/OrcaSlicer/actions/runs/7150314111)), then everything works as it should.

Expected results

This should work

Project file & Debug log uploads

log.zip
project.zip
model.zip

Checklist of files to include

• Log file
• Project file

[FillPavS]

Initially, I made a mistake in determining the version where everything worked and was able to determine the version where it did not work.
Work in - Fixed a bug that caused curled edge detection not to work as expected… https://github.com/SoftFever/OrcaSlicer/actions/runs/7150314111
Doesn`t work in - Port Emboss & SVG gizmo from PrusaSlicer (#2819) and later
Both versions from December 9

[Noisyfox]

Will take a look.