mapiproxy 0.6.3

• Make pcap parsing more permissive. Some traces 'in the wild' have incorrect length fields that don't matter much.

mapiproxy 0.6.2

• Add -o or --output= option to direct output to a file.

• Print timestamp marker before the first message of each minute.

• Support proxying Out-Of-Band (OOB) signals (Linux only).

mapiproxy 0.6.1

• Upgrade mio dependency, it had a security issue.
  Mapiproxy is not affected but we kept getting warnings.

mapiproxy 0.6.0

• No longer default to --messages. It's not clear what the default should be so for the time being it's better to not have a default at all.

• Add experimental --pcap=FILE option to read captured network traffic files written by for example, tcpdump. So far this has seen very limited testing.

mapiproxy 0.5.2

• Add option --color=always|never|auto to control the use of color escapes.
  'Auto' is 'on' on terminals, 'off' otherwise.

• Colorize text, digits and whitespace in binary output. This makes it easier
  to match the hex codes on the left to the characters on the right.

• Support raw IPv6 addresses in LISTEN_ADDR and FORWARD_ADDR, between square brackets.
  For example, [::1]:50000.

• Clean up Unix sockets when Control-C is pressed.

mapiproxy 0.5.1

This release only exists because a version v0.5.1-alpha.1 was uploaded to crates.io as an experiment.

mapiproxy 0.5.0

The basics work:

• Listen on TCP sockets and Unix Domain sockets

• Connect to TCP sockets and Unix Domain sockets

• Adjust the initial '0' (0x30) byte when proxying between Unix and TCP or vice
  versa

• Render either as raw reads and writes, full MAPI blocks or full MAPI messages

• Render as text or as a hex dump

• Pretty-print tabs and newlines

• In raw mode, highlight the MAPI block headers