-
Notifications
You must be signed in to change notification settings - Fork 80
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
TXRX question #132
Comments
@B1tbang3r So as you can read there is better to replace all "Serial." to "Serial1." in all tabs of the .ino and use Pin19 (RX1) and Pin18 (TX1) The baudrate is OK (when not changed in the .ino) with 9600 Baud
If you didnt receive anything is allways a good test to swap the RX/TX Lines.... |
Hi @B1tbang3r . How did this go? |
Hello ,
yes i was , turns out the arduino needed a good reset after power up :)
really enjoying Runcpm just starting to get to know its quirks
Van: "Mockba the Borg" ***@***.***>
Aan: "MockbaTheBorg/RunCPM" ***@***.***>
Cc: "tom van hoorick" ***@***.***>, "Mention" ***@***.***>
Verzonden: Vrijdag 17 september 2021 20:02:37
Onderwerp: Re: [MockbaTheBorg/RunCPM] TXRX question (#132)
Hi [ https://github.com/B1tbang3r | @B1tbang3r ] . How did this go?
Were you able to achieve a solution?
—
You are receiving this because you were mentioned.
Reply to this email directly, [ #132 (comment) | view it on GitHub ] , or [ https://github.com/notifications/unsubscribe-auth/AC6N7V5NROIWFQRVGQ5DWK3UCN7D3ANCNFSM5EFGIB2A | unsubscribe ] .
Triage notifications on the go with GitHub Mobile for [ https://apps.apple.com/app/apple-store/id1477376905?ct=notification-email&mt=8&pt=524675 | iOS ] or [ https://play.google.com/store/apps/details?id=com.github.android&referrer=utm_campaign%3Dnotification-email%26utm_medium%3Demail%26utm_source%3Dgithub | Android ] .
|
Hello ive build runcpm and i verified that its working through the serial monitor in the arduino ide
i hooked up a serial terminal board (esp32 with fabgl) and tried rxtx pin 0 and 1 on the arduino due but nothing
ive set the correct baud settings i think 9600 8N1
is there another pinout i should follow or is this txrx not implememted and only accesible through the usb ports ?
The text was updated successfully, but these errors were encountered: