-
Notifications
You must be signed in to change notification settings - Fork 15
Home
Mark Gardner edited this page Feb 3, 2021
·
2 revisions
Welcome to the JGMaker Artist-D wiki!
- Added Ability to Save EEPROM to Printer instead of SD Card.
- Added the ability to have separate esteps value for each extruder.
- Added JG Bootsplash screen
- Fixed in LCD Pin configuration. Should allow for faster LCD refreshes.
- Fixed Filament Runout sensor triggering change at print start.
- Upgraded Base code to Marlin 2.0.1
- Official Marlin Support for Artist-D motherboard (2.0.1)
- Enhanced SD Card writing to improve card life longevity. (2.0.1)
- Official support for 32bit boards (2.0.0)
- PlatformIO.org build environment this makes setting up a build environment much much easier. (2.0.0)
- Official support for Trinamic TMC2209/8 drivers (2.0.0)
- Linear Advance capable (but not enabled by default) (2.0.0)