v0.4.3

[0.4.3] - 2024-09-28

Fix

• Fix reads with a data bus over 8 bits

Changed

• Depends on dpdumperlib 0.0.4

Added

• 'rb' flag to reverse byte order for read and written files

v0.4.2

[0.4.2] - 2024-09-19

Changed

• Reworded some prints when reading and writing ICs

Added

• 500ms delay after powering up IC, to allow it to settle

v0.4.1

[0.4.1] - 2024-09-14

Fixed

• Pins that are Active-LOW to enable writing on an IC, are now set to high when reading

Added

• Added optional parameters to write mode so that an arbitrary number of addresses can be skipped at the start or at the end of the address space for writing

Changed

• Removed warning that writing is untested

v0.4.0

[0.4.0] - 2024-08-22

Changed

• Depends on dupicolib 0.5.0
• Reading ICs now uses a different protocol that cuts transfer time in roughly half

v0.3.3

[0.3.3] - 2024-08-22

Changed

• Depends on dpdumperlib 0.0.2

[0.3.2] - 2024-08-21

Added

• Flag to output the Hi-Z mask of every read in binary format

Changed

• Use upside-down floor division to calculate number of bytes for data entriess and addresses
• Tool description in argsparse

[0.3.1] - 2024-08-19

Changed

• Depends on dupicolib 0.4.2
• Split out some code in dpdumperlib, now depends on version 0.0.1

Removed

• Example definitions are now moved in the dpdumperlib repo

v0.3.0

[0.3.0] - 2024-08-12

Changed

• Depends on dupicolib 0.4.0

[0.2.1] - 2024-08-12

Changed

• Require dupicolib 0.3.2
• Updated requirements

Added

• Added progress bar to track read/write completion
• Added warning when using write mode
• Added print of IC name when reading

v0.1.0

[0.1.0] - 2024-08-02

Changed

• Changed the definition format, so that pin mapping is specified on a single entry, and everything else use the normal IC pin numbering

Fixed

• Some notes in example TOML files were plain wrong

[0.0.3] - 2024-07-29

Changed

• Depends on dupicolib 0.2.0

Added

• Print the adapter notes when present, and allow them to be skipped
• Add timed notice before starting the self-test
• Read firmware version from board
• Support different command classes depending on model and fw version

v0.0.2 - Initial release

Initial release