Shelly Wave 1PM without Security

[Steph6431]

Hi,

I'm trying to establish an association between a fibaro motion sensor FGMS-001 and a Shelly Wave 1PM.
My understanding is that

1. both devices have to be on the same security level,
2. the Fibaro sensor is not supporting security levels.

So I thought that it would be best to also install the Shelly without security level and excluded the Shelly.
Now I'm trying to include it again but it's not working. When I scan the Shelly QR code the device is added to the provisioning list, where I can modify the security settings.

But how can I get this device finally included?
Disconnecting and reconnecting from power did not help...

Thanks in advance
Stephan

[robertsLando]

When I scan the Shelly QR code the device is added to the provisioning list, where I can modify the security settings.

You should not include the device using the Smart Start QR code if you want to include the device without security, you should instead put the stick and the device in inclusion mode without security.

cc @AlCalzone

[robertsLando]

is directly resulting in the message "Inclusion stopped. Checking for changes..."

With directly you mean immediately or after some seconds? because It should wait 30 seconds and then stop automatically if no node is found

[Steph6431]

Immediately

[robertsLando]

Oh that's strange... Maybe you have changed the default inclusion timeout in settings ? It's under z-wave settings

[Steph6431]

After some reboots I managed to include the Shelly Switch.
Unfortunately I'm still struggling with the association between the Fibaro motion sensor and the Shelly wave switch.

[robertsLando]

What's the issue now during association? Could you tell me the error?

cc @AlCalzone