Y Attachments break when removeing belts

[skyne]

I've installed them in reverse, when realized and tried to remove the belts to swap them, the middle part broke out (see pic.)

Additional info:

• probably I've installed the covers with longer screws than intended
• I've also had white (reinforced, stiff) belts installed, this could've also caused the "harder to remove" effect

[zruncho3d]

Oh, you definitely want to add screws here because the plastic parts are in shear.

This view of Red5's Tri-Zero shows what it should look like, with M3 screw (I think M3x8 or M3x6, would have to check CAD or measure)

[bstrawsma]

I also modified this part when installing it on mine to have a through hole with a heat set insert on the back and then held in place with washers.