reset button

[robomechs]

If you press the reset button during the G4 delay (idle state), this will not stop the program execution.
motion-control.c

// Kill steppers only if in any motion state, i.e. cycle, actively holding, or homing.
// NOTE: If steppers are kept enabled via the step idle delay setting, this also keeps
// the steppers enabled by avoiding the go_idle call altogether, unless the motion state is
// violated, by which, all bets are off.
if ((sys.state & (STATE_CYCLE | STATE_HOMING | STATE_JOG)) ||
(sys.step_control & (STEP_CONTROL_EXECUTE_HOLD | STEP_CONTROL_EXECUTE_SYS_MOTION))) {
if (sys.state == STATE_HOMING) {
if (!sys_rt_exec_alarm) {system_set_exec_alarm(EXEC_ALARM_HOMING_FAIL_RESET); }
} else { system_set_exec_alarm(EXEC_ALARM_ABORT_CYCLE); }
st_go_idle(); // Force kill steppers. Position has likely been lost.

}

[robomechs]

This is a problem: gnea#490 (comment)