Nrf_erase.ufs does not reset RAK4631

[SequoiaGiganteum]

Rak4631 (2.5.18),
Pixel 7 Pro BP22.250103.008
Manjaro Kernel 12.6

I was testing configurations
Right before I changed hop_limit: 999999999
Cable and BT works.
I get telemetry, but I can’t make any changes to the radio configuration. It doesn’t move past 0% with Reboots on both.
Debug shows old configuration
Connected via serial. Applied nrd_erase. Successful File purge.
Download the latest firmware.
Tested with both 2.5.18 and 2.5.20
The old configuration loads, issue not resolved.

[rcarteraz]

Are you using the correct version of the erase file? Make sure you follow the instructions here: https://meshtastic.org/docs/getting-started/flashing-firmware/nrf52/nrf52-erase/

[SequoiaGiganteum]

I did it a bit differently, check out what Bernd Giesecke said below.
https://forum.rakwireless.com/t/reconnection-after-hop-limit-change/14298
I used WB HW T.1.8.uf2 and it wiped it out clean.
I'm sorry for the delay in updating my resolution.

Thank you very much for your reply, I'll try this next time ... 🌊🤙🏻
WB_HW_Test_V1.1.8.uf2.zip