LCD Shields
Product page: http://www.watterott.com/en/RPi-Display
Github: https://github.com/watterott/RPi-Display
Matching case: http://www.watterott.com/index.php?page=product&info=3615
Product page: http://www.raspberrypi.org/phpBB3/viewtopic.php?f=93&t=65566
Product page: http://www.raspberrypi.org/phpBB3/viewtopic.php?f=93&t=69015
Product page: http://www.raspberrypi.org/phpBB3/viewtopic.php?f=93&t=67004
Product page: http://www.adafruit.com/products/1601
Howto: http://learn.adafruit.com/adafruit-pitft-28-inch-resistive-touchscreen-display-raspberry-pi
Touch is not supported by the FBTFT prebuilt kernel. Adafruit provides a custom kernel.
Product page: http://electronics.ilsoft.co.uk/PiShield.aspx
This shield has a joyswitch, and it can be used as a mouse or as a "keyboard". Since the shield doesn't have pullup resistors, we use the internal ones.
Mouse
sudo modprobe gpio_mouse
sudo modprobe gpio_mouse_device pullup polarity=1 up=23 down=17 left=18 right=27 bleft=22
FRAMEBUFFER=/dev/fb1 startx
Ref: gpio_mouse_device
Keyboard, arrow keys and Enter key
sudo modprobe gpio_keys
sudo modprobe gpio_keys_device pullup active_low keys=23:103,17:108,18:105,27:106,22:28
Ref: gpio_keys_device
This keyboard can be used with AdvanceMAME. Set in advance.rc
device_keyboard raw
Ref: MAME
Add to /etc/modules to make it permanent.
On Rev. 1 boards use GPIO 21 instead of 27.
Product page: http://www.watterott.com/en/RPi-ShieldBridge
Blog post: http://lallafa.de/blog/2013/07/watterotts-new-rpi-shieldbridge/
Raspberry Pi to Arduino Shield Bridge
Connect your Arduino Shields with your Raspberry Pi or use our popular MI0283QT- Adapter (2,8“ Color LCD + Touch).
OnBoard you find an ATmega328 with preprogrammed Arduino bootloader.
Product page: http://www.hwlevel.com/PI32/index.html
Forum thread: http://www.raspberrypi.org/phpBB3/viewtopic.php?f=93&t=56131
This display is not supported by FBTFT. They provide a custom kernel.
Product page: https://github.com/Guzunty/Pi/wiki/LCD-Driver-Daughterboard
Product page: http://imall.iteadstudio.com/im130425001.html
Forum post: http://www.raspberrypi.org/phpBB3/viewtopic.php?f=64&t=43702
It's not possible to use the touch panel as a Linux mouse with this adapter. The Touch IC is not wired to the Raspberry Pi SPI bus.
This is not strictly a display shield, but looks to be an interesting product.
Product page: http://www.dfrobot.com/index.php?route=product/product&product_id=1062
