U-Boot 1.1.3 (Aug 28 2016 - 18:48:57) Board: Ralink APSoC DRAM: 128 MB relocate_code Pointer at: 87f64000 ****************************** Software System Reset Occurred ****************************** flash manufacture id: c2, device id 20 19 find flash: MX25L25635E ============================================ Ralink UBoot Version: 4.3.0.0 -------------------------------------------- ASIC 7628_MP (Port5<->None) DRAM component: 1024 Mbits DDR, width 16 DRAM bus: 16 bit Total memory: 128 MBytes Flash component: SPI Flash Date:Aug 28 2016 Time:18:48:57 ============================================ icache: sets:512, ways:4, linesz:32 ,total:65536 dcache: sets:256, ways:4, linesz:32 ,total:32768 ##### The CPU freq = 580 MHZ #### estimate memory size =128 Mbytes RESET MT7628 PHY!!!!!! GPIOMODE --> 50054404 GPIOMODE2 --> 5540551 Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. 0 3: System Boot system code via Flash. ## Booting image at bc050000 ... Image Name: Linux-4.4.14 Image Type: MIPS Linux Kernel Image (uncompressed) Data Size: 4159920 Bytes = 4 MB Load Address: 80000000 Entry Point: 80004b00 Verifying Checksum ... OK OK No initrd ## Transferring control to Linux (at address 80004b00) ... ## Giving linux memsize in MB, 128 Starting kernel ... [ 0.000000] Linux version 4.4.14 (travis@testing-gce-56944157-ef5a-43d4-9bcd-4f468725d8fa) (gcc version 4.9.3 (crosstool-NG v0.7.1) ) #1 Wed Sep 21 17:38:10 UTC 2016 [ 0.000000] Board has DDR2 [ 0.000000] Analog PMU set to hw control [ 0.000000] Digital PMU set to hw control [ 0.000000] SoC Type: MediaTek MT7688 ver:1 eco:2 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU0 revision is: 00019655 (MIPS 24KEc) [ 0.000000] MIPS: machine is MediaTek LinkIt Smart 7688 [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 08000000 @ 00000000 (usable) [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 [ 0.000000] Kernel command line: console=ttyS2,57600 console=ttyS2,57600 rootfstype=squashfs root=/dev/mmcblk0p1 rootwait ro [ 0.000000] PID hash table entries: 512 (order: -1, 2048 bytes) [ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) [ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.000000] Writing ErrCtl register=0006f3d0 [ 0.000000] Readback ErrCtl register=0006f3d0 [ 0.000000] Memory: 125552K/131072K available (3103K kernel code, 148K rwdata, 652K rodata, 184K init, 197K bss, 5520K reserved, 0K cma-reserved) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:256 [ 0.000000] intc: using register map from devicetree [ 0.000000] CPU Clock: 580MHz [ 0.000000] clocksource_probe: no matching clocksources found [ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6590553264 ns [ 0.000011] sched_clock: 32 bits at 290MHz, resolution 3ns, wraps every 7405115902ns [ 0.015349] Calibrating delay loop... 385.84 BogoMIPS (lpj=1929216) [ 0.080516] pid_max: default: 32768 minimum: 301 [ 0.089780] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.102728] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.119243] devtmpfs: initialized [ 0.129867] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns [ 0.149387] pinctrl core: initialized pinctrl subsystem [ 0.160313] NET: Registered protocol family 16 [ 0.178594] mt7621_gpio 10000600.gpio: registering 32 gpios [ 0.189682] mt7621_gpio 10000600.gpio: registering 32 gpios [ 0.200666] mt7621_gpio 10000600.gpio: registering 32 gpios [ 0.212294] SCSI subsystem initialized [ 0.220818] clocksource: Switched to clocksource MIPS [ 0.232635] NET: Registered protocol family 2 [ 0.242077] TCP established hash table entries: 1024 (order: 0, 4096 bytes) [ 0.255787] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.268298] TCP: Hash tables configured (established 1024 bind 1024) [ 0.280942] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.292401] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.305074] NET: Registered protocol family 1 [ 0.314817] futex hash table entries: 256 (order: -1, 3072 bytes) [ 0.334101] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.345942] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.367249] io scheduler noop registered [ 0.374940] io scheduler deadline registered (default) [ 0.386490] Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled [ 0.400866] 10000c00.uartlite: ttyS0 at MMIO 0x10000c00 (irq = 28, base_baud = 2500000) is a 16550A [ 0.419423] 10000d00.uart1: ttyS1 at MMIO 0x10000d00 (irq = 29, base_baud = 2500000) is a 16550A [ 0.437530] console [ttyS2] disabled [ 0.444544] 10000e00.uart2: ttyS2 at MMIO 0x10000e00 (irq = 30, base_baud = 2500000) is a 16550A [ 0.461869] console [ttyS2] enabled [ 0.461869] console [ttyS2] enabled [ 0.475597] bootconsole [early0] disabled [ 0.475597] bootconsole [early0] disabled [ 0.493265] spi-mt7621 10000b00.spi: sys_freq: 193333333 [ 0.504783] m25p80 spi32766.0: using chunked io (size=31) [ 0.515544] m25p80 spi32766.0: mx25l25635e (32768 Kbytes) [ 0.526273] 4 ofpart partitions found on MTD device spi32766.0 [ 0.537829] Creating 4 MTD partitions on "spi32766.0": [ 0.548014] 0x000000000000-0x000000030000 : "u-boot" [ 0.559265] 0x000000030000-0x000000040000 : "u-boot-env" [ 0.571182] 0x000000040000-0x000000050000 : "factory" [ 0.582516] 0x000000050000-0x000002000000 : "firmware" [ 0.602975] rt3050-esw 10110000.esw: link changed 0x00 [ 0.614427] mtk_soc_eth 10100000.ethernet eth0: mediatek frame engine at 0xb0100000, irq 5 [ 0.631448] mt7621_wdt 10000120.watchdog: Initialized [ 0.641691] MTK MSDC device init. [ 0.680913] mtk-sd: MediaTek MT6575 MSDC Driver [ 0.691270] NET: Registered protocol family 10 [ 0.702237] NET: Registered protocol family 17 [ 0.711187] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this. [ 0.736193] 8021q: 802.1Q VLAN Support v1.8 [ 0.749704] mtk-linkit bootstrap: Version : LINKITS7688D [ 0.760460] mtk-linkit bootstrap: Revision : REV3 [ 0.770263] Waiting for root device /dev/mmcblk0p1... [ 0.810646] mmc0: new high speed SD card at address b368 [ 0.822017] mmcblk0: mmc0:b368 UD 953 MiB [ 0.832397] mmcblk0: p1 p2 [ 0.885040] VFS: Mounted root (squashfs filesystem) readonly on device 179:1. [ 0.906690] devtmpfs: mounted [ 0.913652] Freeing unused kernel memory: 184K (803d2000 - 80400000)