Heltec v3 firmware 2.5.11 - configuration doesn't fully restore

[overlord23]

Hi folks

I came across an issue while restoring the configuration on my Heltec V3, here's the steps applied:

• issued nodedb reset and factory reset
• configured node and exported config with Meshtastic CLI
• issued nodedb reset and factory reset again
• restored config from Meshtastic CLI - serial output printed out ERROR | 22:25:38 593 Unknown config type 10
• exported config from Meshtastic CLI and compared with the previously exported yml

The following parameters included in the configuration file didn't restore:

• autoScreenCarouselSecs:
• txPower
• adcMultiplierOverride
• root (lora region)

Am I missing something or this could be a bug?

Environment:

Board: Heltec V3
Firmware: 2.5.11
Meshtastic CLI: 2.5.4

[fifieldt]

Just for reference -- "ERROR | 22:25:38 593 Unknown config type 10" is not a problem.

You are right that the others should restore

[fifieldt]

Do you have full logs available?

[overlord23]

Here are the serial log collected while uploading the configuration and the debug log after uploading.
debug_aftrestore.txt
serial_log_cfgrestore.txt

[overlord23]

I managed to get a Heltec Wireless Stick Lite V3 and replicated the previous steps, the issue happens also with wsl firmware

[lucaskatayama]

I get something like this...

1. Export config
2. Change mqtt.enable from true to false
3. Apply with --configure <YAML> --port /dev/<PORT>
   Doesn't change anything...

BUT
Using bluetooth (--ble <name>), it works...
It only happens with serial port ....