What is the correct setup for using this card with Tesla Powerwall (and Solar)?

[ziptbm]

I've posted a couple times in this thread in the HA Community, but haven't found anything definitive. So, what's the best way to use this card with the integration for Tesla Powerwall (and Solar)?

[flixlix]

I don't have any Tesla related products so I can't tell you exactly but it should be pretty straight forward to setup.
You just need to have the Powerball values inside of HA and remember the entity ids of each sensor. Then inside your Lovelace dashboard, select the power Flow card plus from the card picker and input the ids

[ziptbm]

Thanks, yes I’ve got it working, however it is reporting scenarios that are impossible at the time due to my configuration settings on the device like grid to battery, so there’s something about the combination of the official integration sensors and this card that’s causing it to show energy flow that isn’t accurate.

It’s not all the time, just sporadically and I think it’s because the sensors are reporting small values above and below zero even though they’re really at “zero.” So the zero tolerance is set, but it seems like it only offsets the positive scenario and not the negative. @flixlix is the zero offset for positive only by design or should it cover both sides when using a combination sensor?

I’ve shared my config in this thread https://community.home-assistant.io/t/power-flow-card-plus/552326/126