2_How to

Compiling and launching procedures

Open a terminal. Launch IDL

$ IDL

Inside IDL, procedures are compiled as:

IDL> .r procname

And then launched as:

IDL> procname [, key=value, key2=’stringvalue’, /option]

Inside the command line, the various arguments must be comma—separated. If the procedure accepts input values, they are structured as key-value pairs. When the value to be passed is a string, it must be enclosed in ‘ ’. If options are available for a given procedure, they are enabled by using /

Calling sequence

separate:	Used to reorganize the dataset in band-separated folders and, inside them, according to th nature of the source (flux calibrator, target, skydip)
opacity:	(Optional) Used when needing to estimate the tau0 values, which are needed to compensate the subsequent calibrators/targets measurements inside the pipeline
dataflagging:	(Optional) Used to visually inspect and flag each single subscan in the dataset It exploits an interactive GUI
runcalib:	Used in order to analyze the cross-scans acquired on flux density calibrators and to extract the counts-to-Jy factors to be then employed in the target data calibration.
c2jtimeline:	Used in order to reconstruct a timeline (averaged values or linear interpolations) of the counts-to-Jy conversion factors
runtarget:	Used in order to reduce and calibrate the cross-scans acquired on target sources
srcaver:	(Optional) Used in order to reprocess runtarget’s output and average the different measurements on a target basis