You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Describe the bug
For certain models if I slice them with supports disabled I get a warning about large overhangs suggesting I enable supports. If I enable supports and slice again the warning disappears, but no supports are added
Hey everyone, I hope you're doing well. It seems like the issue still hasn't been resolved. Just to provide some further information, it seems that the occurrence of the issue is affected by the layer height of the print. For instance, when the layer height is set to 0.2, the issue doesn't occur, but when it's set to 0.1, it does.
Describe the bug
For certain models if I slice them with supports disabled I get a warning about large overhangs suggesting I enable supports. If I enable supports and slice again the warning disappears, but no supports are added
3mf File for This Bug
18650_x_3_battery_holder.zip
To Reproduce
Steps to reproduce the behavior:
Printing on textured plate with PETG using Generic PETG profile if that matters, but I'm 95% sure I've seen this happen with PLA on cold plate too.
Expected behavior
Supports should only be recommended to me if slicer is actually going to add supports
Desktop (please complete the following information):
The text was updated successfully, but these errors were encountered: