You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
There are actually two separate bugs in this case:
If time lapse and sequential printing are both enabled, the tool head hits the previously printed objects on its way to the excess chute (to take the photo for the time lapse video).
The slicer suggests to add time lapse wipe tower to the plate, but in sequential print order the tower is printed out separately.
The text was updated successfully, but these errors were encountered:
@YifanWuBambu, does that mean that timelapse without toolhead has also been disabled for object-by-object printing, or can it now calculate a path to avoid previously printed objects/print them in an order front-back?
@YifanWuBambu, does that mean that timelapse without toolhead has also been disabled for object-by-object printing, or can it now calculate a path to avoid previously printed objects/print them in an order front-back?
Does that mean that timelapse without toolhead has also been disabled for object-by-object printing?
Yes. And we will add another timelapse type (snape a picture after a fixed interval), which can be used in the by-object printing.
Can it now calculate a path to avoid previously printed objects/print them in an order front-back?
In by-object print, if we still use "timelapse without toolhea", each object needs an individual prime tower.
That will take a lot of area of the build plate, and the video effect may not be very good.
There are actually two separate bugs in this case:
The text was updated successfully, but these errors were encountered: