Replies: 4 comments 8 replies
-
Each LaserGRBL button (excluded the first 3 buttons) are customizable. M0 is the command you need. Try something like this: G0 X[left] Y[bottom] |
Beta Was this translation helpful? Give feedback.
-
PS: if you double click anywhere in your preview LaserGRBL rapid move your laser head in this position. |
Beta Was this translation helpful? Give feedback.
-
Thanks so much for the great advice! Did not know a double click would move to that location, but made the button as well and will take it out to my shop to load it up and give it a test. Now another question where I may be pushing my luck- Can you zoom in/out in the workspace? Not necessary, but wasn't sure if I was overlooking something. |
Beta Was this translation helpful? Give feedback.
-
This works for me. G0 X[left] Y[bottom] Also, answer to your other question. No you can't zoom in or out. |
Beta Was this translation helpful? Give feedback.
-
I am relatively new to LaserGRBL and love the product so far. I wanted to know if this button exists. I've used Full Spectrum software and there is a button that runs the boundary of the project, but stops at each corner- click the button again and it goes to the next corner. This is a great option for fine-tuning your work location. Does this exist for LaserGRBL or is there something I can do for this rather than code? A button would be nice.
Beta Was this translation helpful? Give feedback.
All reactions