How to configure template to show entity in HA? #21801
Unanswered
Dexter0007
asked this question in
Q&A
Replies: 2 comments 1 reply
-
The way is to config the led as a "Relay" pin, as you already saw working. Or maybe as a PWM, to also have variable brightness. Pins configured as a "Led" are local status leds, not intended to be seen as separate features. |
Beta Was this translation helpful? Give feedback.
0 replies
-
The problem is that the pin set as Relay can be switched from HA. In my device, GPIO25 is supposed to be the alarm signal (read only) from the device. |
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hi, I'm trying to configure my custom device by template for display binary_sensor or output in Home Assistant in Tasmota integration (NOT MQTT).
If I set GPIO25 as Relay that Switch appears in HA, but if I set anything else, the entity disappears.
How can I get entity with ON/OFF state in HA ?
Beta Was this translation helpful? Give feedback.
All reactions