Amt not configuring

[laramy2020]

I have a dell Latitude 5320, it only has wifi, but it's bios claims network passthrough to thunderbolt which i have enabled and plugged in.

I have tried both the agent and the usb configuration and amt will not configure

./meshcmd amtinfo

Intel AMT v15.0.45, pre-provisioning state.
Wireless Disabled, DHCP, 00:00:00:00:00:00
Connection Status: Unknown, CIRA: Disconnected.

Os is a fully up-to-date arch system

/dev/mei0 exists

[laramy2020]

oh here is the meshcentral config

[si458]

And what happens now if u restart the Linux machine then run the amtconfig from the console tab of the device?
Is it still the same error saying no amt?

[laramy2020]

still says no amt

[laramy2020]

you know i did search the issues before, i guess my search terms where bad #3846

[laramy2020]

i created an amt only area, it shows up but does not allow configure if i do it via the webui

If i try with meshcmd commands it then asks for credentials, and i give it the credentials i made and it just gets stuck on trying credentals

i do have an ! in my password, could that also cause issues?

[si458]

@laramy2020 Sadly, im out of ideas, also as the other issue explaines, all AMT issues are on hold because we have no AMT development/developer

Without access to hardware, we can't fully look into issues :(

I only have 2 devices myself, an AMT V7, and AMT v12 on 2 different dell machines (6th processors), both have Windows installed so can't just uninstall and reinstall windows because the amt provisioning is separate!

If anyone is willing to donate money or hardware, I do have a donation page setup https://www.si458.co.uk/2024/01/05/donation/