MEPLHAA Script issue

[toddc01b]

Hi,

Could somebody have a look at the MEPLHAA Script below and help me to understand why the button I have connected to GPIO 2 isn't working?
I've got the board set up so it switches a GND to pin 5 momentarily which then changes the state of the the output on GPIO 5 each time it's pressed. It used to work with 11.8 but since upgrading to 12 and writing the new MEPLHAA Script I haven't been able to get it to work. The relay connected to GPIO 5 is working from the home app just fine and the temperature probe connected to GPIO 4 is also working.

{
"c": {
"io": [[[5],2], [[0,2],6], [[4],1]]},
"a": [{
"0": {"r": [[5, 0 ]]},
"1": {"r": [[5, 1 ]]},
"t": 1,
"s": 0,
"d": 0,
"b": [[2, 1]]
},
{
"t": 22,
"j": 10,
"n": 3,
"g": 4,
"z": 0
}
]
}

[toddc01b]

All good. I figured it out. Just needed to invert the input.

{
"c": {
"io": [[[5],2], [[2],6,1], [[4],1]]},
"a": [{
"0": {"r": [[5, 0 ]]},
"1": {"r": [[5, 1 ]]},
"t": 1,
"s": 0,
"d": 0,
"b": [[2, 1]]
},
{
"t": 22,
"j": 10,
"n": 3,
"g": 4,
"z": 0
}
]
}