You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
so.
I have Tronxy X5SA with board CXY-466-V10.1-220921 based on GD32F427ZET6.
it looks simular to ST32F446.
I try to buid marlin firmware, an everythink goes good. All motor/extruder/nozle/bed/ works fine.
But I can't store configurating to eeprom. Command M500 gives error.
Cli says "EEPROM ERROR Version missmatch and EEPROM ERROR datasize. Configuration.zip
attach configuration
and second trouble with screen
Bug Timeline
No response
Expected behavior
No response
Actual behavior
No response
Steps to Reproduce
No response
Version of Marlin Firmware
BugFix2.1.X
Printer model
Tronxy X5SA
Electronics
CXY-466-V10.1-220921
LCD/Controller
Tronxy display
Other add-ons
No response
Bed Leveling
None
Your Slicer
None
Host Software
None
Don't forget to include
A ZIP file containing your Configuration.h and Configuration_adv.h.
Additional information & file uploads
No response
The text was updated successfully, but these errors were encountered:
CXY-466-V10.1-220921 based on GD32F427ZET6. is not a board that is supported in stock Marlin at this time
We only have the older CXY-446-V10-220413/CXY-V6-191121 (STM32F446ZE) Wich is not the same, and has a very different chip
CXY-466-V10.1-220921 based on GD32F427ZET6. is not a board that is supported in stock Marlin at this time We only have the older CXY-446-V10-220413/CXY-V6-191121 (STM32F446ZE) Wich is not the same, and has a very different chip
The original Tronxy Marlin seems to work well.
If you have any idea to resolve this problem, i can try it.
Did you test the latest
bugfix-2.1.x
code?Yes, and the problem still exists.
Bug Description
so.
I have Tronxy X5SA with board CXY-466-V10.1-220921 based on GD32F427ZET6.
it looks simular to ST32F446.
I try to buid marlin firmware, an everythink goes good. All motor/extruder/nozle/bed/ works fine.
But I can't store configurating to eeprom. Command M500 gives error.
Cli says "EEPROM ERROR Version missmatch and EEPROM ERROR datasize.
Configuration.zip
attach configuration
and second trouble with screen
Bug Timeline
No response
Expected behavior
No response
Actual behavior
No response
Steps to Reproduce
No response
Version of Marlin Firmware
BugFix2.1.X
Printer model
Tronxy X5SA
Electronics
CXY-466-V10.1-220921
LCD/Controller
Tronxy display
Other add-ons
No response
Bed Leveling
None
Your Slicer
None
Host Software
None
Don't forget to include
Configuration.h
andConfiguration_adv.h
.Additional information & file uploads
No response
The text was updated successfully, but these errors were encountered: