Issues with Tuya shutters since v1.39.00

[ElCaplar]

Hello everyone,

Following an update to Zigbee2MQTT 1.39.00 , I have noticed strange behavior with some of my roller shutters (specifically those with modules recognized as TUYA-TS130F. I have 2 other MOES modules [MS-108ZR] that are working correctly).

When I fully raise the shutter, the status visible in Home Assistant is "closed" even though the shutter is open. Below is the trace from the development menu:

state : closed
current_position: 100
backlight_mode: null
calibration: "OFF"
calibration_time: 32
indicator_mode: "off"
linkquality: 255
motor_reversal: "OFF"
moving: STOP
position: 100
friendly_name: volet-salon
supported_features: 15

On zigbeemqtt interface here is :

{ "calibration": "OFF", "calibration_time": 32, "indicator_mode": "off", "linkquality": 255, "motor_reversal": "OFF", "moving": "STOP", "position": 100, "state": "OPEN" }

The shutter appears closed while it is actually open. When I click on "STOP," the status updates correctly

I am experiencing exactly the same strange behavior when I close the shutter, as it appears to be in open mode. When I use intermediate positions, there is no issue.

When i downgrade on 1.38.00 version, all is ok.

Do you have any possible solutions or workarounds for this behavior?