Skip to content

Latest commit

 

History

History

case

Folders and files

NameName
Last commit message
Last commit date

parent directory

..
 
 
 
 
 
 
 
 

TOTEM CASE

Each half consists of a bottom and a top part (with an integrated switchplate) and is meant to be 3D printed in resin.

I got good results from JLCPCB (15€ + tax and shipping for a black or white version) and PCBway (50€ + tax and shipping for a clear case).

Where possible use the STEP files, but the STL files should be fine too.

If you're sure you only will use the wired version you can also use the case without a power switch (USB) or use the case without a TRRS cutout if you plan on using the wireless version (BLE).

Note The manufacturer will probably warn you about too thin sections, but it worked fine for me since these sections are pretty small.

TOTEM case

Tenting

Tenting is possible using the provided bottom plates found in the tenting folder. These bottom plates are compatible with their corresponding non-tenting top part. The tenting bottom plates are compatible with the same screws as the non-tenting bottom plates.

TOTEM tenting height comparison

Note Using these tenting bottom plates (left) the keyboard height will be increased by the thickness of the tenting feet (around 4mm). Compared to the default bottom plate (right).

The tenting bottom plates are designed for these laptop risers. These are attached using the provided adhesive and sit flush with the bottom of the plate.

TOTEM tenting bottom

This system enables two tenting options: 13 and 20 degrees. The feet allow for an even higher tenting option but this is not officially supported due to design constrains for top piece compatibility.

For optional extra grip whilst tenting there is a recess made at the pinky key designed for anti-slip adhesive pads, such as this one