Printing
NOTE: If you plan on using the Tapchanger Dragonburner dock you must use the custom cowl by OstroMa. We always recommend to use the original cowls when possible and the Modular Dock does not require any special Cowl, print the original from the Dragonburner repo.
Coming Soon
All print settings are the same as Voron Standards or better.
Print orientation is flat on the parts back with supports enabled currently, we are working on models with integrated supports.
If you print the shuttle and backplate and things are just not smooth or you have slight binding, you can Heat Treat it and here is how.
- Full assemble the shuttle and backplate with Bushing, Pins, Screws and Magnets
- Set your heatbed to 100-110°C
- Once at temperature set mate both parts fully, and set them on the bed with the backplate (tool side) down
- After 20+ minutes pick them up and slide them 3-4 times, then fully reseat them
- Let them cool without touching them for 5+ hours
- Try them again and you shoudl see an improvement if it's still not 100% feel free to repeat the Heat Treatment
Big thank you to unguided-wanderer on Discord for this technique.